Bob Dishwasher

SOLUTION: Unplug all other appliances  connected to the same electrical  circuit as Bob. Replace the fuse or  reset the circuit breaker.

SOLUTION: Check that the power cord is  properly plugged in at both ends,  into either the wall outlet or on  Bob’s side.

SOLUTION: Close the door.

SOLUTION: Check whether something is blocking the closing of the door or the seal. If it is not the case, please contact the After Sales Service.

SOLUTION: If you are in the “integrated tank” mode: fill the tank up until the signal sounds. If you are in the “water supply” mode: check your installation (tap open, sufficient pressure).

SOLUTION: Wait 3 seconds until Bob has started. If the screen is still frozen, disconnect and reconnect Bob.

SOLUTION: Check the drain hose and fix it with “Bob Easyfix”.

SOLUTION: Clean the bottom of the interior and the filters.

SOLUTION: Contact the After Sales Service.

SOLUTION: Avoid special dishwasher detergents to avoid foaming. However, if this happens, open the dishwasher door and allow the foam to evaporate. Close the door and start a wash program to drain the water. Repeat the procedure if necessary.

SOLUTION: Different types of debris generate more or less foam. However, if there is too much foam during a cycle it can block the spray arm. In this case, empty the basket and run an empty cycle before you start washing your dishes again.

SOLUTION: Avoid any contact between the different items in the basket. Please refer to page 17: Recommendations for the arrangement of dishes in the basket.

SOLUTION: Choose a more intensive program. Refer to page 22: Standard programs

SOLUTION: We recommend using a Bob Tablette

SOLUTION: Change the arrangement of the dishes so that the spray arm can rotate freely.

SOLUTION: Disassemble and clean the spray arm as described on page 33

SOLUTION: Refer to page 17: Recommendation for the arrangement of dishes in the basket.

SOLUTION: We recommend using a Bob Tablette.

SOLUTION: Choose a program with a longer washing time.

SOLUTION: Check that nothing prevents the door from opening automatically at the end of the cycle.

SOLUTION: Wait for the signal tone at the end of the cycle before taking out your dishes.

SOLUTION: The tank capacity is 4 litres. If you are in the “integrated-tank” mode, do not overfi ll it. If you are in the “water supply” mode: switch your water supply off and call the After Sales Service.

SOLUTION: Check the condition and position of the seals on the door and whether something prevents the door from closing completely.

SOLUTION: Use the supplied clamp and the screwdriver to tighten the drain hose on the back of Bob. (See page 3 and 4)

SOLUTION: Check the connection and tighten it. (See page 3)

SOLUTION: Contact the After Sales Service

SOLUTION: Do not put any fragile cutlery in Bob(see page 17)

SOLUTION: (N/A)

SOLUTION: Restart Bob by unplugging and then plugging it in again.

SOLUTION: Drain your Bob completely with the emptying cycle (Settings menu), then start an empty cycle. Leave the door open at a 10° angle, if Bob is not in use.